1. "FEM in the Angle Steel Rolling." Report to DFG (the German Research Society), August 6, 1994 (in German).

2. "Use of the Finite Element Method in the Production of Angle Steel Section." Stahl und Eisen 115 (1995) No. 2, pp. 61-65 (in German).

3. "Compared Numerical and Experimental Studies of Angle Steel Production Process." 39th Mechanical Working and Steel Processing Conference. Iron & Steel Society, Indianapolis, IN., October 1997. 39TH MWSP CONF. PROC., ISS, vol. XXXV, 1998, pp. 705-719.

4. "Application of Finite Element Simulation in Shape Rolling." Accepted by the 1998 AISE Annual Convention, September 1998 in Pittsburgh, PA.

5. "Interactive Relation of Rolling Process Models in an Automatic Roll Pass Design Program." Accepted by the 40th Mechanical Working and Steel Processing Conference, Iron and Steel Society, Pittsburgh, October 1998.

6. "FEM - an Effective Tool for Development and Design in Shape Rolling." Submitted at the request of the Technical Editor of the Iron and Steel Engineer as feature writing for the Issue June 1998.

7. "Metallurgical, Modeling and Software Engineering Issues in the Further Development of the Steel Mill Level 2 Models" (10 pages). AISTech 2008. Associate of Iron and Steel Technology (AIST), May 2008.

8. "Level 2 Model Improvements at Evraz Oregon Steel Mills" (11 pages). Accepted by AISTech 2008, AIST (Ready for publishing).

9. "Issues on Further Development of the Steel Mill Level 2 Models". Chapter of the book Flat-Rolled Steel Processes Advanced Technologies. CRC Press, edited by V. Ginzburg.

10. "The State-of-the-art of Infrared, Laser and Microwave based sensors and system." Chapter of the book Flat-Rolled Steel Processes Advanced Technologies. CRC Press, edited by V. Ginzburg.

11. "Next-Generation of Level 2/Level 3 Models with Metallurgical Prediction and Intelligent Learning." To be published.